|
We now manufacture an arch-style pizza oven out of Timbercrete. Not only does it have the fire-proof qualities of all Timbercrete products - it looks and cooks good too!
Construction:
 Each oven is constructed using an arch at either end, one with the front opening. These are stood upon a section of cement sheeting and concrete pavers for heat retention.
At the base on either side are square long blocks - available with a raked or smooth face. Then the angled long blocks are evenly mortared into place around the sides of the arch, and the final keystone long block can be cut to allow for a flue to be installed. The entire oven can be built in less than a couple of hours!
|
Customisation:
 All Timbercrete products are creatively oriented - you are free to do as much or as little modifications as you wish:
You can see in out photos that we have added some Bullnose pavers as an apron to the oven. We have also added a galvanized pipe as a flue in front of the door for ventilation, and used a paver as a door for slow-cooking foods.
It is also quite an option to render the inside and out of the oven with a render mix to provide further insulation, and give the oven a smoother appearance.
You can decide to do as much or little as you wish!
|
Kits:
|
 We can provide a few variants of our pizza oven kits, depending on your requirements:
- The front and rear arch panels, and the long blocks
- As above, with cement pavers and cement sheeting for the base
- As above, with Timbercrete cobblestone blocks for a full stand
If you’re interested in our pizza ovens, send us an email at riverina@timbercrete.com.au, or ring at the factory: (02) 60 297 888 for prices and further information.
|
|
